AEG KVH 32 Guida di Installazione

KVH, TracVision, and the unique light-colored dome with dark contrasting baseplate are registered trademarks of KVH Industries, Inc. All other tradema

11Follow the steps below to seal the cable access hole.a. Seal the cable access hole on the deck with a liberal amount of silicone sealant, RTV, or eq

12Follow the steps below to wire your receiver(s).a. Connect the RF1 cable from the antenna to the grounding block, as shown in Figure 18. Label this

13Follow the steps below to wire your receiver.a. Connect the RF1 cable from the antenna to the “Satellite In” connector on the receiver (see Figure 2

14Follow the steps below to wire the switchplate.a. Connect the antenna’s power/data cable to the switchplate’s power/data connector and lock in place

15Find your U.S. or Canadian satellite TV service below to determine which service key(s), if any, you need to install. Store any unused service keys

16Follow the steps below to mount the switchplate.a. Fit the switchplate flush into the panel cutout you made in “Cut Out the Switchplate Hole” on pag

17Follow the steps below to configure the TracVision system to track a pair of linearly polarized satellites. To complete this procedure, you will nee

18Follow the steps below to determine the ideal skew angle for your location and selected satellite(s). You will set the LNB to this angle in the next

19Follow the steps below to set the antenna’s LNB to the skew angle you determined in “Find the Skew Angle” on page 18.a. Turn off the antenna and dis

20Follow the steps below to set up the system for your desired satellite TV service (if necessary) and test the system for proper operation.a. Stop th

3Before you begin, follow these steps to make sure you have everything you need to complete the installation.a. Unpack the box and ensure it contains

21Give the Welcome Kit to the customer and explain how to use the product. Also be sure the customer understands the following:• The receiver(s) must

23AppendicesThis section includes the switchplate mounting template and provides supplemental instructions for special or advanced configurations.Cont

25Connecting 3 or More ReceiversAIf you need to connect three or more receivers, or you set up the system for DISH Network’s 129 satellite (one or mor

26Although most installations do not require different satellites than those listed in “Install Service Key(s)” on page 15, you may set up your TracVi

27Switchplate TemplateCPanel Cutout0.16"(4 mm)3/32"(2.25 mm) dia0.32"(8 mm)2.05"(52 mm)3.19"(81 mm)2.36"(60 mm)3.82"

4Before you begin, consider the following installation guidelines:• Minimize blockage. The antenna requires a 15° to 75° look angle to receive satelli

5Follow the steps below to remove the mounting plate.a. Remove the eight screws and washers securing the radome to the baseplate (see Figure 5).b. Car

6At the bottom of the antenna, two tie-wraps prevent the internal antenna assembly from moving during shipment. Follow the steps below to remove these

7Follow the steps below to drill the antenna mounting holes.a. Place the mounting plate on the deck at the location you chose in “Plan the Installatio

8Follow the steps below and refer to Figure 11 to mount the antenna to the mounting surface.a. Apply a bead of silicone sealant around each mounting h

9Follow the steps below to cut out the switchplate mounting hole.a. Using the switchplate mounting template supplied in Appendix C on page 27, mark an

10Follow the steps below to wire the antenna.a. At the location you chose in “Plan the Installation” on page 4, use a 3/4" (19 mm) hole saw to cu