AEG LAV88830-W Manuale Utente Scaricare il pdf (Pagina 23)

Instructions for use

Start the washing program

0 1. Check that the water valve is open.

2. Start the washing program:

Press button START/PAUSE (START/PAUZE).

The washing program is started or it starts

after the set time expires.

If DOOR/LIGHT (DEUR/LICHT) flashes red when the START/PAUSE

(START/PAUZE) button is pressed the filling door is not closed properly.

Press the filling door shut firmly and press START/PAUSE (START/PAUZE)

button again.

If the time preselection is set:

The preset delay timer is counting, the remaining time until the

program starts is shown in the multi-display (always in whole hours).

During this time you can load washing or change/abort the time

preselection.

• Load washing: Press the START/PAUSE (START/PAUZE) button, the

filling door can be opened. Then close the door and press START/

PAUSE (START/PAUZE) button again.

• Change or abort time preselection: Press the button DELAY TIMER

(STARTTIJDKEUZE) as often as is necessary until the required time is

displayed; when the program run time is displayed (display in min-

utes, e.g.125) the washing program starts without delay.

While the time preselection counts the washing machine switches to

the stand-by mode. Only RUN TIME (LOOPTIJD) is illuminated, the

multidisplay shows the remaining time until the program start. All

other displays on the control panel are switched off in order to save en-

ergy. Pressing any arbitrary button cancels the stand-by mode.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 55 56

Nessun commento

AEG LAV88830-W Manuale Utente Pagina 23